Need metal roof installation in Big Bend? We come look first, tell you plainly what it needs, and put the price in writing before anything starts.
We have been setting metal panels on houses, churches, barns and additions for over twenty years, and the crews serving Big Bend install them the same way we always have. Straight lines, correct fastener spacing, and closures at the ridge so wind driven rain has nowhere to go.
Not every Big Bend roof needs the biggest job on the sheet. When we quote metal roof installation we tell you honestly whether a repair will hold, whether doing one section will do, or whether you are genuinely past that — and we would rather do the smaller job well.
Metal is our specialty, so if metal roof installation on your Big Bend home opens the door to standing seam or a panel roof, we will price that right alongside the shingle option and let you compare the real numbers side by side.
Four steps and no surprises. This is how we have done it since 2002.
We measure the roof on site, count the valleys, hips and penetrations, and bring the color chart so you can hold it up against your siding.
Where the decking is sound and there is only one layer, we can often go over the top on purlins. We tell you which one your house calls for.
We keep panels straight to a line rather than to the eye, because a metal roof shows every bit of drift the moment the sun hits it.
Ridge caps, closures, drip edge and gable trim finish the roof and keep wind driven rain and wasps out from under the panels.
What comes up on just about every estimate for a job like this.
Around twenty standard colors. Green, burgundy, bronze, black, gray, tan and barn red are the ones most Big Bend homeowners land on. We bring the chart with the estimate so you can hold it against your siding.
Sometimes. If the decking is sound and there is only one layer of shingles, a Big Bend metal roof can go over the top on purlins. Two layers or rot underneath and we tear off first — and we say so before you sign.
Most Big Bend metal roof jobs land between about $12,000 and $30,000 in 2026, depending on square footage, pitch, panel type and how much tear off is involved. Standing seam runs higher than exposed fastener panels. We measure before we quote and the estimate is free.
Much less than people expect. Over solid decking with underlayment, a Big Bend metal roof sounds about like a shingle roof from inside. The loud tin roof people remember was screwed to open purlins on a barn.
Real feedback from homeowners we have worked for.
"They reroofed the porch and matched it to the house so well you cannot tell where the old work stops and the new starts."
"Thank you so much to the entire crew at Roofing Brothers for our amazing new tin roof! You were amazing to work with and I couldn't recommend you to others enough! Great communication, pricing, color options, efficiency, and HONESTY! If anyone needs a new roof, I highly recommend this crew! Phenomenal job."
"They replaced the soffit and fascia the squirrels had chewed through and closed everything back up tight. No more scratching in the attic at night."